My Car Computer
Hardware Specification
Hard to find hardware and custom made interfaces for Car Computer
160W DC-DC Automotive PSU
160 watts output
Extra wide input voltage 6-30V
Intelligent shutdown controller
"Anti-Thump" amplifier remote control
Supports Sleep MODE, supports Remote (ignition) signal.
Over voltage, Over current, thermal and short circuit protection.
Survives vehicle engine cranks
Protects battery, avoids the deep discharge and shuts off automatically.
Dual 15A x 2 automotive fuse (mini-blade)
High Efficiency, 88% typical
Board Size : 160mm x 45mm
Mounting hole size: 145mm x 37mm dia. 3.5mmRoyalTek RGM-3600 USB GPS Receiver
Chipset: SiRF Star III
Frequency: L1, 1575.42 MHz
C/A code: 1.023 MHz chip rate
Channels: 20 channel all-in-view tracking
Sensitivity: -159 dBm
Accuracy Position: 10 meters, 2D RMS; 5 meters, 2D RMS, WAAS enabled Velocity: 0.1 m/s
Datum Default: WGS-84
Acquisition Time: 1/35/42 sec (hot/warm/cold)
Main power input: 5V DC input
Power consumption: 50mA
Baud rate: 4,800 bps
Output message: NMEA 0183 ver 3.0,GGA, GGL, GSA, RMC and VTG, GSV
Operating temperature: -20°C to +60°C
Dimension: 48.4 x 48.4 x 15.1 mmBluetooth OBDII interface*
Multi protocol supportSAE J1850 PWM (41.6 kbaud)
SAE J1850 VPW (10.4 kbaud)
ISO 9141-2 (5 baud init, 10.4 kbaud)
ISO 14230-4 KWP (5 baud init, 10.4 kbaud)
ISO 14230-4 KWP (fast init, 10.4 kbaud)
ISO 15765-4 CAN (11 bit ID, 500 kbaud)
ISO 15765-4 CAN (29 bit ID, 500 kbaud)
ISO 15765-4 CAN (11 bit ID, 250 kbaud)
ISO 15765-4 CAN (29 bit ID, 250 kbaudBluetooth connection to PC
* Not all Indian cars are OBD II compliant
Steering wheel remote control USB interface
Connect your stearing wheel resistive remote control to PC using USB
Connect up to 2x15 keys
Keys can be freely mapped to functions in the frontend software
Supports 2 voltage detection inputs to implement functions like auto dimming when headlights on or switch to camera mode when reversingReverse parking sensor USB interface
TBD
